Sinusoid Settings…

Displays the dialog box shown below used to set the frequency and level if sinusoid is selected as output signal.

The Frequency can be set no higher than half the sampling frequency. Note that if you close the dialog box and open it again, the frequency will have changed slightly from the value you have typed. This is because it has switched to the nearest possible exact frequency. The frequency resolution is increased by increasing the sequence order in the Measurement Settings Toolbar.

The Level [dB FS] is the full scale level given in Decibels. Its maximum value is 0, which is the maximum amplitude for the Digital-to-Analog converter. The output level may be further adjusted using the volume settings.