Sound Devices that have been tested not work with WinMLS
Some sound devices do not support simultaneous play and record and therefore cannot run WinMLS. Most of the newer cards support simultaneous play and record operation, but may not work with WinMLS due to errors in the hardware or with the driver.
The list below shows the cards that have been tested and been shown not to work with WinMLS. If this is because of a bug in the sound device driver, note that the sound device may work with future releases of the driver. It is also possible that some of these have an internal sampling of 48 kHz, this means that they will work properly only at sampling frequencies 48, 24 and 12 kHz.
USBPre 1.5 – this is a USB device with built-in microphone preamplifier. Very nice, but because of synchronization problems it can’t be used for MLS measurements. The AD and DA seem not to use the same clock.
Roland USB Audio Interface (UA-30) – had synchronization problems.
SonicPort – This is a device for the USB port. It seems to work fine, but in full duplex mode it does not work properly and we were not able to get correct measurements using this device.
LP600 – did not seem to work.
Turtle Beach Montego – synchronization problems. Sampling frequency 48 kHz might work.
Turtle Beach Montego 2– synchronization problems. Sampling frequency 48 kHz might work.
Yamaha DS-XG – synchronization problems. Sampling frequency 48 kHz might work.
Event Darla, Layla and Gina - synchronization problems.