should be checked if the measurement is to be performed in loop-back mode. Then the settings below must be set.Synchronization Mode – Measurement of initial time delay, or not.
should be checked if the measurement is to be performed in loop-back mode. Then the settings below must be set.
The initial time delay is the same as the time a pulse takes to travel through the system we are measuring. Typically the distance from the loudspeaker to the microphone. This can be measured in several ways when measuring transfer functions with WinMLS.
These settings only apply when measuring transfer functions and not when measuring in scope mode.
Each of the items in the list shown in the figure above is explained in the chapters below.
Only if my sound card `is synched'
No, detect start of measurement
Yes, my sound card `is synched'